Blue with Red Stripe and Solid Navy Blue
Standard pen blank sizes are 3/4″ diameter by 5″ long, and prices are for a set of two blanks (blue with red stripe blank & a solid navy blue blank)
The Alumilite Advantage!
Alumilite is by far the best resin I’ve found for casting pen blanks. It’s a joy to turn, yet it polishes up to a high gloss. Finishing these blanks doesn’t get any simpler! Just sand it up to a high grit or use micro mesh pads, then finish it off with some plastic polish or on a buffing wheel.
GOOD BYE CHIPOUT!! Alumilite blanks are not brittle like many of the mass produced or polyester resin blanks on the market. The blanks are cast under pressure to ensure there are no voids or trapped air bubbles in the blanks.
These blanks are created using a laminating method. With proper turning techniques, these blanks will turn fabulous. Improper turning or machining techniques can lead to lamination failure, however. Make sure you are turning at high speeds (over 3,000 rpms) and only use sharp tools when turning. Also, make sure you get proper glue coverage and bonding along the entire length of the tube and blank. Adhesion problems can occur if there are large areas lacking glue coverage between the tube & blank.